Thank you Cayman Auto Services! You can read detailed warranty information on our warranty page. Other services such as transmission work and suspension repair may also be expensive, though they occur less frequently on the A4. Can't recall if you go clockwise or counterclockwise, but it will be evident. In the photo, one of the slot keepers is visible even with my thumb. There are metal slot keepers in the slot which will make it harder.
However, if you prefer to order your Audi soft top by telephone, we have a toll-free number that you are welcome to make use of. Installation: This is the real reason I have written this. The cloth must be far enough forward to have the front edge wrap around frame and go into the slot in the underside. Thought it could be the angle sensor, but did nothing about it. Partially move the top to the down position until the hinge bends and you can access the end piece. I believe the antenna is the copper-colored plate. I tested for continuity on the motor and it was not an open circuit.
In case of any queries, or if you would like any more information of the workshop manual drop me an email facebook. Regards, Khurrum, 07834770567, Sent from my iPhone using Tapatalk Hi Khurrum, First of all, thank you for putting this up and keeping up on it for the past five years. I find if I insert the key and manually close the roof and then turn the key back and forth a few times, and then try again it will sometimes then work - both up and down, no problems. I then took off the casing plugged the motor in attached the alligator clips to the copper wires attached to the brushes. Tied the fishing line to the s-hook and used it to pull it through. Here is what TopsOnline customers are saying.
Sometimes we moved the frame without the use of the motors. Started the car, tried to open the top, still no reading. . Faulty motors on the power windows and door locks can also be to blame. There should be new clips in the groove on the window. Basically just run the steps backwards. Don't believe the fault codes! Will I lose some hydraulic fluid in the process, the Audi fluid is very expensive.
I am a do-it-yourself kind of guy. The tool will hang down by itself. Are there any detailed instructions for taking the motor assembly apart to get access to replace the brushes? Also available are alternative less expensive convertible top fabrics including vinyl. We offer a variety of Audi tops in a variety of top-quality materials. Remove the side keepers on the front panel.
Same issue is as follows: Top will open to the point where the rear windshield needs to operate. The Audi A4 convertible has been involved in several recalls for dealers to attend to known issues. You may have noticed that at the corners, there was some glue between the cloth and the rubber weather-stripping. During the winter, enough water seeped through to leave the back panel a mess and stain the headliner a bit. If you can hook it, do so and reinstall those 3 wedge strips. Remove the plastic molding under the lead edge of the convertible top.
Do anything to keep the zipper from unzipping. A very small drill was used after I flattened the copper. More than I wanted to spend. When the service message appears on screen - press 0. VagPro provides very detailed photographic instructions with his kit We bench tested the motor on reassembly and all was well. Use the staples that you pulled out.
That was in October or November, I didn't bother and fixed it, when it broke down again I phoned back in the spring and the prices had rocketed. The tool needs to be jiggled to go 'all the way' in. Then it would get stuck down and not go back up. Again with a needle nose pliers, pull down on the cloth. Regards Khurrum VagPro Sent from my iPhone using Tapatalk Hi Khurrum, I'm near Leeds so sadly not just up the road from you, in Leicester.
Notice that there is a small silver hook in the frame attached to a wire cable. I tested for continuity on the motor and it was not an open circuit. Then attached some fishing line. Once this panel is removed, remove the three bolts holding the amplifier. I'm not to sure where to look now. And that still did not solve the issue.