2010 polaris ranger 400 oil change. 2010 Polaris SportsmanĀ® 400 H.O. Reviews, Prices, and Specs 2019-01-18

2010 polaris ranger 400 oil change

Shop Polaris Lubricants

2010 polaris ranger 400 oil change

Squeeze the end of the rub- ber boot and slide it far enough to expose the end of the inline cable adjuster. Loosen the wheel nuts slightly. An ignition key can be duplicated only by ordering a Polaris key blank using your key number and mating it with one of your existing keys. Set the gear in neutral and apply the parking brake. As coolant operating temperature increases, the expanding heated excess coolant is forced out of the radiator, past the pressure cap, and into the overflow bottle.

Next

Polaris Engineeredā„¢ Oil Change Kit

2010 polaris ranger 400 oil change

Twice a year I try to change all the fluids in my 2011 Polaris Ranger. The connections are behind the console, under the hood. The soundtrack for this channel is provided by my band, so the two are intertwined. Position the vehicle on a level surface. When operating on slippery surfaces such as ice or loose gravel, reduce speed and use extra caution to reduce the chance of skidding or sliding out of control. Am perfectly happy with it.

Next

2010 POLARIS RANGER 400 POLARIS OIL CHANGE KIT

2010 polaris ranger 400 oil change

Oil from your skin leaves a residue, causing a hot spot that will shorten the life of the lamp. I agree, Polaris is putting their name on someone else's oil. Follow the instructions on the container for the recommended amount. Wet brakes may have reduced stop- ping ability. Chrome wheels exposed to road salt or salt in the air in coastal areas are more susceptible to corrosion if not properly cleaned. Apply the brakes while starting the engine.

Next

Shop Polaris Lubricants

2010 polaris ranger 400 oil change

A collision or rollover can occur quickly, even during routine maneuvers like turning, or driving on hills or over obstacles, if you fail to take proper precautions. Check the friction pads for wear, damage and looseness. Spring Adjustment Adjust the front and rear shock absorber springs by rotating the adjustment cam either clockwise or counter-clockwise to increase or decrease spring tension. This vehicle handles differently than other vehicles, such as cars, trucks or other off-road vehicles. Transmission Synthetic 1290 ml 19. Allow lamps to cool before servicing.

Next

POLARIS RANGER 400 HO OWNER'S MANUAL Pdf Download.

2010 polaris ranger 400 oil change

Do not service axle nuts that have a cotter pin installed. Inspect the level of the brake fluid before each operation. A collision can occur with another vehicle. Promptly replace worn or damaged cab nets and latches with new cab nets and latches. Position the vehicle on a level surface. Place shop towels under the oil filter. Remove the dipstick and pour the new oil into the oil tank.

Next

Engine Oil & Lubricants

2010 polaris ranger 400 oil change

Failure to follow the safety precautions could result in serious injury or death. I use Rotella T synthetic, and used the non-syn for several years. Never operate this vehicle on any public street, road or highway, including dirt and gravel roads unless designated for off-highway use. In this video I change the front differential fluid, the engine oil and filter, and the rear end transmission fluid. If necessary, apply them lightly several times to let friction dry out the pads.

Next

Shop Polaris Lubricants

2010 polaris ranger 400 oil change

Attach the wheel nuts and washers and finger tighten. Run the engine for 15 to 20 seconds. Turn the engine off, clean the area around the drain plug at the bottom of the oil tank, place a pan to catch the oil underneath the drain and then open the drain to release the oil inside. Telephone 763-542-0500 We, Polaris Industries Inc. If the engine is over-choked when warm, depress the throttle pedal fully while cranking to aid in starting. Carbon Clean removes water from fuel systems, stabilizes fuel and removes carbon deposits from pistons, rings, valves and exhaust systems.

Next

Polaris Engineeredā„¢ Oil Change Kit

2010 polaris ranger 400 oil change

Test your brakes after leaving water. When removing the battery, always disconnect the negative black cable first. Always change the oil filter whenever changing oil. All 3 series of Kolpin Plow Systems can easily mount to virtually all machines and we offer 5 different blade sizes to match your needs. Improperly performing the procedures marked with a could result in component failure and lead to serious injury or death. The manual says use 2w-50 synthetic, which the dealer sells. Both of these units share the same, smaller, two-seat chassis, that fits in the back of a pickup truck, with many of the hardest working, smoothest riding features of their full-sized counterparts: On-Demand True All-Wheel Drive with VersaTrac, Independent Rear Suspension, heavy duty front end protection, high ground clearance and the longest suspension travel in their class.

Next